Scrubber for a 60 cube

[leeit2me]

Well started my project today. Been reading alot about ATS and I wanted to try it. I am currently running GFO,GAC and bio pellets. Still getting some cyno and some HA on the rocks, but not too bad though.

So, following the new guide line in DIY ATS, I am going to make a screeen size of 5x9. I want to keep it small enough to fit into my sump area. And I am going to use LED for this.

I know you guys love pics. :D

http://i1000.photobucket.com/albums/af128/leeit2me/ATS/IMAG0032.jpg
the unit itself, all glue up and plumbing testing.


http://i1000.photobucket.com/albums/af128/leeit2me/ATS/IMAG0033.jpg
Top view of it.

http://i1000.photobucket.com/albums/af128/leeit2me/ATS/IMAG0034.jpg
Use coupling to easy cleaning.

http://i1000.photobucket.com/albums/af128/leeit2me/ATS/IMAG0035.jpg
Other side.

So, I don't know if I want to go with the Morgan or slots...

[sklywag]

Nice work.

[MorganAtlanta]

I say no slot...

[mess7777]

I say no slot...

+1 , it works great for me.

[Floyd R Turbo]

I'm curious as to why you extended the notched ends higher than the long sides, the primary point of spray is from the area near the pipe.

[leeit2me]

I'm curious as to why you extended the notched ends higher than the long sides, the primary point of spray is from the area near the pipe.

Well, my mistake as I miscalculated the measurement. (remember to measure TWICE and cut once).. :( But don't worry I will jerry-rigged something up to prevent the water spray.