PDA

View Full Version : Quick disconnect system?



yesman
09-15-2009, 01:33 PM
Is there a quick disconnect system for releasing scrubber screen (as attached to its pipe) from the feeder pipe for easy weekly cleanings, something like the one used on garden hoses?

I think using a domestic hose pipe connecter would mean too small a hole for water to travel through, fitted into 1" water supply pipework from sump pump.

Im looking at a sreen of 28x9" =252sq inches so whatever gallons p/h that adds up to?

SantaMonica
09-15-2009, 02:39 PM
Here are some good ways to attach the screen to the pipe:



http://www.radio-media.com/fish/CurtainRings.jpg

http://www.radio-media.com/fish/UserJeffg57onAS-15.jpg

http://www.radio-media.com/fish/RugCanvasAttach.jpg

http://www.radio-media.com/fish/UserJeffg57onAS-15.jpg




"Huhhhhh" on the MB site did this:
http://www.radio-media.com/fish/UserHuhhhhhOnMB-03.jpg




"IamFood" on the SG site did this:
http://www.radio-media.com/fish/UserIamFoodOnSG.jpg




"Murfman" on the SCMAS site did this:
http://www.radio-media.com/fish/UserMurfmanOnSCMAS-4.jpg
http://www.radio-media.com/fish/UserMurfmanOnSCMAS-5.jpg

yesman
09-17-2009, 07:55 AM
Thanks for those innovative ideas, I like the idea of attaching the screen to the pipe as a permanent fixture, as its tuff stuff (the plastic screen) and disconnecting at the point where the water feed pipe connects to the screen holding pipe, so I can just quick release, lift the whole pipe/screen out for weekly cleaning.

Any ideas around practicle quick disconnect of water feed pipe?

Thanks, this is an inspiring site!

kcress
09-17-2009, 10:33 PM
Unions are very easy to separate pipes with. You don't even need movable pipes to use them.

SantaMonica
09-17-2009, 10:34 PM
Be sure to use light-shields, to keep algae from growing into the slot.

yesman
09-18-2009, 11:44 AM
Kcress your a star, of course Unions!

Santa, funny I was thinking about that very question, very important to have. What do you suggest as a permanent fix for this?
Almost needs some sort of U shaped pipe or something to just sit over the pipe and low enough to shield the light.

SantaMonica
09-18-2009, 02:08 PM
Tank divider frames are easy:

http://www.radio-media.com/fish/UserJdlOnAS-2.jpg