PDA

View Full Version : Questions about Cycling a New Fresh Tank with a Scrubber



Toddo
09-30-2009, 07:34 PM
I'm performing a fishless cycle on a new freshwater tank. I have a new scrubber and also a canister running on it. I would eventually like to just run the scrubber, if possible.

The tank has been filled with well water, so no ammonia or chlorine. The canister has seeded bio media in it. For 3 days I have been adding ammonia to get the nitrogen cycle started. The scrubber will eat the ammonia as well as the canister. It is starting to grow a haze of algae, but not much. My ammonia levels are at about 2ppm.

My questions are... will this work, and am I going about this the best way possible? Should I just be concerned with the algae growth and not so much the canister media? Thanks.

SantaMonica
09-30-2009, 09:12 PM
I have seen many tanks cycled with a scrubber, and for whatever reason, there is very little growth until the tank is stocked and fed. But at least the scrubber will be ready.

schnitm
10-01-2009, 11:41 AM
I started a screen with "waste" water from water changes on my smaller tank. It did work. The small tank during some of that time had moderately high phosphate and nitrate levels.

I think the problem with well water + ammonia + salt mix (I assume?) is nutrient limits. This link is interesting: http://en.phyco.org/wiki/Nutrient_Requirements

I suspect that your well water + salt mix is limited in one or more required nutrients. Ammonia gives the nitrate but other things are needed.

Toddo
10-01-2009, 05:07 PM
Thanks. There's no salt as this is a freshwater tank.

I am wondering if adding ammonia to get the nitrogen cycle started in both the scrubber and a seeded canister filter is the correct way to go.

Both are trying to consume the ammonia, and typically I'd see a nitrate spike when the canister bio has been established. However, the scrubber will also be consuming nitrates at some point... so how will I know? More algae on the screen?

There is definitely a learning curve here. (not a bad one though)

We need Algaescrubber.net T Shirts!

Toddo
10-06-2009, 05:30 AM
Well, its been two weeks of fishless cycling with ammonia and algae is starting. :D

SantaMonica
10-06-2009, 08:17 AM
Nice. You did rough up that screen, right?

Toddo
10-06-2009, 08:57 AM
Yes...to the point of almost shredding it. As you stated, a holesaw is by far the best way to do that.

And currently, all the algae that's starting is in those scratches.

Toddo
10-09-2009, 07:30 PM
More Progress, 3 days later.....still no fish, ammonia only.

kcress
10-10-2009, 12:09 AM
Coming along.

Toddo
10-13-2009, 06:26 PM
Coming along nicely. Fish are going in tomorrow.