Search:

Oops, froming looking at my collection of pics I uploaded, I guess that pic wasn't the roughing one. :( but hey, you get the idea, right?

oh by the way, did you guys notice when you roughing up the screen with the hole saw bit, you create a "directional"roughness. Meaning when you run your hands after roughing it, one direction is kind...

LOL.. I think it's rough enough.. at one spot it's like almost paper thin.. that how much I rough it up with the hole saw bit.. \

I use 18 gauge strand wire. it was what I had on hand from my...

yes, screen was rough up. you can"t see it, since I have that clear sheet plastic over it and the flash doesn't help either.

Time to update my progress on this project. I have finish the UAS and it's currently running. Playing with the light schedule now. But everthing else is fully operational. Best part of this? There ...

Thanks! Working with acrylic is alot more forgiving than glass.

I kept this design to accommandate my sump area. Since I have a 15gal sump, there isn't much room to play with. And plus my cost to...

Thanks!!.

Today, I finish test fitting the input pipes. Marked all the connection points for final gluing and assembly. Will start masking the area to be painted.

updated photo's.
...

Well folks time to change direction from the water fall to the up flow scrubbers. I have converted my water fall scubber into the UAS. I have incorporated to be hung on the side of the sump.. Also...

Well, my mistake as I miscalculated the measurement. (remember to measure TWICE and cut once).. :( But don't worry I will jerry-rigged something up to prevent the water spray.

Well started my project today. Been reading alot about ATS and I wanted to try it. I am currently running GFO,GAC and bio pellets. Still getting some cyno and some HA on the rocks, but not too bad...