Ok well I have a 120 gallon tank with no filtration at all right now, just a few power heads. I was going to put one of my L1 scrubbers on it for a tester for that. now I'm thinking that I should build the box w/o the bottom drain and try top of tank again with this new design. Since I won't have to deal with massive flow through the box creating microbubbles in the tank I bet it would work much better. Going to be hard keeping that secret if I have someone come over to pick something up and they want to look at my tank.
I also have a couple 10g tanks and could do some FW. might get to it this weekend.
This is great
no slot tube
can't dry out on outage
no need to shut off flow to clean
I could go on
Main question though is related to my scrubber boxes I am building now. This is my prototype L2 without the bottom hole for the bulkhead, which I forgot to drill before bonding.
(Looking back on it, I'm thinking that forgetting this hole was somehow meant to be)
I can't see how there are any implications for me selling this box as a type-I scrubber. Converting this to a type-2 is simple as I previously described. However the second this hits the general public in May I guarantee you I am going to get people wanting one made for the type 2 scrubber (i.e. no bulkhead in bottom, etc). So how do I handle that with all your embodiments etc?