SantaMonica's HOG.5

[SantaMonica]

Subscribe to this topic Here

Also check out the new SURF2 Here


















9-day cleaning vid:
http://www.youtube.com/watch?v=h0K4UCp9_aA



Day 1:


Day 2:


Day 3:


Day 4:


Day 5:


Day 6:


Day 7:


Day 8:


Day 9:

[Garf]

With quick results like this I think you're gonna sell a shed load of these

[ruddybop]

did you use CFL or LED....

[Garf]

did you use CFL or LED....

Look at the video, obviously some alien power source, wicked!

[Bobba]

Very impressive SM. I recently posted about a DIY UAS using an Aquaclear 50 HOB but this might be a better option for me. A couple of questions if I may? What is needed to drive the ,leds and since the screen and bubbler (I assume) are siliconed in place, what if they needed replaced? I did not see any holes except on top. So, I am assuming the unit must be mounted higher to eliminate releasing bubbles into the display, correct?

[ruddybop]

Look at the video, obviously some alien power source, wicked!

Oh lol.... I missed that link right at the top in front of my face...buisy looking at the pics... .... Thank You.....

[SantaMonica]

Thanks, glad you like it.

LEDs use a simple LED driver, available at the same places that sell the LEDs.

If the screen needed replacing, you would just cut the silicone out with a knife.

If the bubbler needed replacing, you would just pull it off; it does not have too much glue. Then glue a new hose, cut it, and adjust the segments for even flow.

It also has holes on the bottom. Can be mounted higher than the waterline, as in the Day 1 though 5 pics, or below the surface, as in the Day 6 through 9 pics. Below the surface makes less sound, and circulates more water through the cover; thus it will collect more floating particles as is shown in the pics. But of course it makes bubbles

[Garf]

I'm converted!

[Rogue]

How do you make two tray attached each other between glass/acrylic?

[SantaMonica]

Magnets