I have just made a scrubber and the slot i cut was the width of a hacksaw blade so about 1-2mm.Is this big enough as i am getting the odd bit of water spraying away from the mess after its been running for a few hours.
I have just made a scrubber and the slot i cut was the width of a hacksaw blade so about 1-2mm.Is this big enough as i am getting the odd bit of water spraying away from the mess after its been running for a few hours.
3 to 4 mm is the recommended slot width. I used a dremmel grinding wheel, run at high speed in a drill. These are 3.5 mm in width and perfect for slot pipes.
I run mine through my table saw. BE CAREFUL!!! I set my blade very low.
150G. Reef/Mix
125G. 3 Regular Oscars/1 Jack Dempsey
75G. 20+ Africans
40G. Fish/Reef. Algae Scrubbers on ALL my SW
10G. SW Fish/Reef.
10G. SW Hospital/new fish quarantine/pod breeder tank
6 stage RO/DI system 200 GPD.
Ok thanks will make mine abit bigger
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
