You can coat them in epoxy, twice, instead if you like.
You can coat them in epoxy, twice, instead if you like.
Hey Sm I have a tube of JB water weld I was thinking I would press a thin layer on the plastic case then add the crushed coral.
next question is there a difference running a upflow vertical or horizontal the bubbles would still be going up the CC
The JB should be fine. And the angle should not matter much.
yeah I tested a small amount of Jb weld then added the CC I think it gonna work great!!
Ok now on to the bubbles. if i remember right the best way to do it is cut along the air tubing ( in the middle ) then every so often maybe an .5" make a slit across the tubbing.
sound about right?
Yes, or you can make crosscuts too, to allow you to open the segments and clean inside.
I think I know what you mean but got a photo?
I was thinking of using a TOMs aqua lifter for the bubbles is there a better quitter one out there?
thanks SM for all the help
http://algaescrubber.net/forums/atta...3&d=1399603666
Aqualifter is way to little. I always recommend the Fusion 700 or the Tetra Whisper AP300
yeah thanks what i was thinking after realizing it quit small GPH...
Has anyone used the Danner Aqua Supreme AP-8 Aquarium Air Pump, 7-watt?
was thinking it might be a good idea as it controllable and has 4 outlets.
I want to try my hand at a pod growing station for a mandarin =1 outlet
the ATS =1 outlet
possable 2nd ATS
not sure id I should get one with more outlets? new to air pumps... but if i use all 4 will it decrease the air flow per outlet?
anyone know?
You can combine the outlets and they should add up to the total of the separate ones. Put 2 outlets on the scrubber.
There are currently 1 users browsing this thread. (0 members and 1 guests)