+ Reply to Thread
Page 3 of 3 FirstFirst 123
Results 21 to 24 of 24

Thread: RAIN2

  1. #21
    Administrator
    Join Date
    Oct 2008
    Location
    Santa Monica, CA, USA
    Posts
    10,245
    All other waterfall algae scrubber designs (which we created in 2008; see Ats2008.org) require you to disconnect and disassemble the unit to get to the growth on the bottom tray. This was a problem. The RAIN2 and RAIN4, which we created to solve this issue, allow you to lift off the LED dome lid with one hand so you can observe any growth on the tray, and then you can lift the tray off of the water pipe also with one hand (as shown) to take it to your sink. And you never have to turn off the water flow when doing this.

    Click image for larger version

Name:	rain tray growth 2.jpg
Views:	15
Size:	71.1 KB
ID:	8336

  2. #22
    Administrator
    Join Date
    Oct 2008
    Location
    Santa Monica, CA, USA
    Posts
    10,245
    Inside a RAIN2 dome LED lid, showing two of the four GEM5 lights plugged in and operating on opposite sides of the screen, with one higher and one lower, so that the screen is not saturated on both sides with light at any one spot (this is a typical step for a new screen that is filling in).

    Click image for larger version

Name:	WfDutchSnootsOnAS-4.jpg
Views:	13
Size:	87.7 KB
ID:	8346

  3. #23
    Administrator
    Join Date
    Oct 2008
    Location
    Santa Monica, CA, USA
    Posts
    10,245
    RAIN2 which looks like the first week operating in high-nutrient water. One of the GEM5 lights is turned on, at the bottom on one side. Note the good even flow of water off the bottom of the screen.

    Click image for larger version

Name:	WfDeoGalang-6.jpg
Views:	3
Size:	69.3 KB
ID:	8391

  4. #24
    Administrator
    Join Date
    Oct 2008
    Location
    Santa Monica, CA, USA
    Posts
    10,245
    RAIN2 waterfall algae scrubber from a saltwater sump, showing black slime growth that has just been brushed clean. Dark and black slime like this should be brushed completely off, including out of the screen holes, because the slime cannot hold on well to a waterfall screen (it can however hold on well to Green Grabber rocky textures in upflow models).

    http://algaescrubber.net/forums/show...he-best-filter
    http://algaescrubber.net/forums/show...-it-looks-like

    Click image for larger version

Name:	rain2 black slime.jpg
Views:	2
Size:	87.1 KB
ID:	8398

+ Reply to Thread
Page 3 of 3 FirstFirst 123

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts