I need help wiring up the ballast for the nano light. The socket has four postions, and the ballast only has three leads. Two reds and one yellow. Can anyone help me with a wiring diagram.
thanks,
Tim
I need help wiring up the ballast for the nano light. The socket has four postions, and the ballast only has three leads. Two reds and one yellow. Can anyone help me with a wiring diagram.
thanks,
Tim
I forgot to mention I am using the workhorse 2 ballast and the light Santa Monica recommended. I have all the acrylic work done and I an trying to figure out the lighting . I have a small 25g nano tank.
Thanks,
Tim
Two reds get tied together; two yellows get tied together. They can go on any pin, like this:
red red
yel yel
Thanks,
However, as I stated earlier, I have two reds, and only one yellow. Is the yellow common between two pins?
Thanks,
Tim
Yes, any adjacent pins. Same with red; you can eliminate one the of long reds if you want, and just use the remaining red on the two remaining adjacent pins.
Thanks,
I will post some pictures when I get everything finish. I did make a couple of changes to the original design, however, it was more to accommodate my setup then improvements.
Have a great day
There are currently 1 users browsing this thread. (0 members and 1 guests)