Collector UAS...
Collector UAS...
doesn't it the bubbles will be too slow & tend to stick on the screen with this set up? will it have the same effect then if yes, compare using the air pump?Originally Posted by SantaMonica
Collector UAS...
You can control how many bubbles by how high above the water you place the overflow hose. Also, you can use a venturi.
Hello everyone, what do you think about this UAS sump design ?
The two holes on the left are there for 1.5" bulkhead fitting for the water comming from the display tank
The main intention on this design is to have dry compartments for placing the UAS lamps, the bubble collector will have a lid with small holes for vent, after the bubble collector that compartment is for liverock rubble, then bubble trap and pump compartment.
Let me have your thoughts on this
Probably want to reverse the bubble remover... under over under.
Also might want to test the overflow to see how many bubbles you get at that depth.
Why would you do that? Almost every sump design I have seen has it up-down-up. If you have the first one down, you get no surface skimming before the baffle and you end up with a layer of scum.
Because for bubbles it works better; the bubbles stay at the top. Otherwise, if you are going to let the bubbles (and scum etc) spill over the first part, why have a first part.
Weres this months release?
Water level is way to high for me.. i would lower the baffles and uas area so you have space for any back syphon that may occurr
Going to be 2 months instead of 1.
There are currently 6 users browsing this thread. (0 members and 6 guests)
Posting Permissions
Reply With Quote